WarmlyYours 510-10-120 Installation Guide

Installation Manual for your ENVIRON II Floor Heating System

10IMPORTANT POINTS FOR THE CARPET FITTER:Please ensure that compatible carpet cushion and carpet are being fi tted.Remember that you are laying carpet

11RESTRICTIONS ON FURNITURE PLACEMENT AND PRECAUTIONS IN USE:Always remember that you have a thin electrical appliance installed directly below your c

12SECTION 3: INSTALLATION UNDER WOOD LAMINATE:BEFORE YOU STARTEnviron II panels must be fi tted directly on top of the underlayment, and directly unde

13INSTALLING THE PANELSOnce the underlayment has been fi tted in the normal manner, remove your Environ II panel from the packaging tube, unroll it com

14Note that the power supply cables of Environ II panels are matched to the rated power of the panel. If more than one panel is connected to a thermos

15LIMITED WARRANTYThis Environ II Heater is guaranteed for a period of 5 years from date of purchase against any fault caused by a manufacturing defec

167. The heater should be used strictly in accordance with the following:a) Hard wire the unit into a 110 Volt ~ properly sized circuit. If a single

2INTRODUCTION:Thank you for purchasing the Environ II Electric Radiant Floor Heating Panel. This manual contains IMPORTANT information regarding the s

3TABLE OF CONTENTS:SECTION 1: GENERALUnderstanding Your SystemControlling Your SystemProfessional Electrical InstallationThe Safety of GFCINothing On

4SECTION 1: GENERALUNDERSTANDING YOUR SYSTEM:Environ II panels are made of a pattern of a fi xed-resistance heating element, “sandwiched” between two l

5CONTROLLING YOUR SYSTEM:WarmlyYours recommends that the SmartStat programmable thermostat control the Environ II heaters. The SmartStat come with a fl

6Electrical ConduitLocal electrical codes often require the power leads be installed inside a metal or plastic conduit when running behind the wall fr

7TROUBLE SHOOTING - Checking Ohm resistance and circuit continuityCAUTION: TURN OFF ELECTRICITY BEFORE TROUBLESHOOTING SYSTEMIf the system fails to he

8SECTION 2: INSTALLATION UNDER CARPETNEVER CUT OR TRIM Environ II panels to fi t into a space that is too small.BE AWARE of the risk of damaging the he

9INSTALLING THE THERMOSTATIf you are using a thermostat with a fl oor sensor, tape the sensor to the top surface, or the bottom surface, of the Environ